Drag Click Test: Count Registered Clicks

Run a short test you can compare

1. Choose 5 or 10 seconds. Use five seconds for a short sample, or ten for a longer window. Keep the same duration, mouse and browser for the runs you want to compare.
2. Check an ordinary click, then Reset. Click once inside the pad and confirm the count changes. Select Reset before measuring your chosen technique so the trial click is not mixed into the result.
3. Keep the pointer inside the pad and begin. The first valid click starts the timer. Keep this tab visible until completion; avoid clicking with another input method or activating the focused pad with the keyboard during a mouse-only run.
4. Record the count and final CPS. Select Reset for another run. Compare several complete runs on the same setup instead of treating the largest single number as a universal score.

Moving the pointer is not the measurement. The page counts primary-button click events that reach its pad. Moving across the pad, holding a button down or dragging a page item does not itself generate a series of counted clicks. This counter cannot tell which hand technique produced the events.

The test length is locked while the timer runs. If you hide or leave this page, the measurement is cancelled; return and select Reset for a fresh run. Reset clears the count and result while keeping the selected duration. This behavior applies to this drag click test.

Understand CPS and the equivalent interval

The window ends before the deadline click. A click received exactly at, or after, the end of the selected duration is excluded. If you stop clicking early, the remaining idle time still lowers your full-window CPS. The timer does not end just because your clicking stops.

Equivalent interval is not a measurement of your actual gaps. A burst followed by a pause and evenly spaced clicks can produce the same total. The auto clicker speed test separately reports recorded average gaps and gap spread. Use the CPS and interval calculator for a theoretical conversion.

These results describe input received in this browser window. They do not establish a maximum CPS for your mouse, verify a gaming result, or show how another application handles the same input.

If you see no clicks, one click or an unexpected score

• First confirm the pad receives an ordinary click. Reset, click once in the middle and check the count. If it does not register, try the mouse-button test to see which input the browser receives.
• Check the target and button. Keep the pointer on the pad. This test excludes right and middle clicks; the right-click test measures right-button CPS.
• Separate input methods. Keyboard activation and touch can produce primary click events too. Do not mix them into a mouse-only comparison.
• Compare like with like. Record the duration, device and browser with the score. Changing the setup or pausing mid-run makes a direct comparison less useful.
• Do not diagnose hardware from this score alone. A low count shows that few clicks reached the pad; it does not establish the cause. The double-click test can help inspect the gap between two registered clicks, but also cannot identify a physical fault by itself.

For a general manual baseline, open the CPS test. For a page that generates its own A/B/C demonstration, use the online auto clicker demo. This drag click page only measures arriving events; it does not generate clicks or control another page or app.